Yamaha DT200L 1984-1988 Service Manual page 89

ENGINE ASSEMBLY AND ADJUSTMENT
ENG ^L
Clutch and Primary Drive Gear
1. Install:
• Clutch push lever axle aseeembly
2. Set the push lever axle spring (2) to its
position.
TH
r:
3. Install:
• Balancer gear (D
• Drive gear
NOTE:
Note that there is the punched mark (3) on the
drive gear and punched mark (3) on the balancer
gear which must be aligned to install the balancer
gear.
.
CD
\^
4. Install:
• Key (Balancer gear)
• Lock washer (New lock washer)
• Balancer gear nut
• Key (Drive gear)
• Primary drive gear
• Spring washer
• Primary drive gear nut
5. Tighten:
• Primary drive gear nut
• Balancer gear nut
Place a folded rag (3) between the teeth of
the drive gear (4) and balancer gear (5) to lock
them.
Primary Drive Gear Nut:
80 Nm (8. 0m. kg. 58 ft. Ib)
Balancer Gear Nut:
55 Nm (5.5 m. kg, 40 ft. lb)
3-37