Cleaning The Rollers - Microtek NDT-2000 User Manual

Cleaning the Rollers

Prolonged used of the digitizer may result in accumulation of ink and other
residue on the feeder's rollers, affecting their efficiency. Clean the rollers
periodically to maintain performance.
Rollers are found in two areas of the NDT-2000: Directly on the digitizer, and on
the inner side of the front cover.
To clean the rollers inside of the digitizer:
1. Push down two Release buttons at both sides of the front cover of the
2. When the front cover is opened, you can find several groups (4 sets) of
NOTE:
•
•
•
42 NDT-2000 User's Manual
digitizer and open the front cover.
When opening the front cover, support the both sides of the front cover with
your hands, avoiding suddenly falling down of the front cover.
rollers located at the inside of the digitizer. Clean the rollers with a lint-free
cloth or a swab moistened with alcohol or ECO cleaner, as shown in the
graphic below.
Remember to clean all rollers inside of the digitizer at one time.
Wipe off dirt and stains from the surfaces of the rollers horizontally while
cleaning. Do not wipe them vertically in order to avoid dropping off dirt or
stains into the interior of the scanner.
While cleaning, wipe rollers only toward the same direction. Do not wipe
back and forth over the surface of the rollers.