SMC Networks S0700 Series Manual page 48

S0700
Series
How to Add Manifold Stations (Plug-in Type / Lead Wire Connection Type)
What to order
Manifold block assembly (Refer to page 655.)
Steps for adding stations
Loosen hexagon bolts from the end plate at the U side and remove the
end plate.
Connect the tie rod for increasing the station number, open the junction
cover, mount the manifold block assembly and U-side end plate and
tighten them by hexagon bolts.
(Tightening torque: 0.85 to 0.95 N m)
Connect lead wire assemblies included with manifold blocks as follows.
Socket housing
Convex part
Take out the socket housing and connect the black and white lead wires.
The connection layout is common to all kits.
Convex part
656
Tie-rod for station additions
Junction cover
SOL.A
Red
SOL.B
SOL.B
SOL.B
White
Black
Terminal no.
COM. Red 1A
2 stations Black 2A
3 stations White 3A
4 stations White 4A
5 stations White 5A
6A
7A
8A
9A
10A
11A
12A
13A
Hexagon socket head screw
Tightening torque: 0.85 to 0.95 N m
U side end plate
Tightening torque: 0.25 to 0.35 N m
Round type terminal
1B Red COM.
2B Black 1 station SOL.A
3B Black 3 stations SOL.A
4B Black 4 stations SOL.A
5B Black 5 stations SOL.A
6B Black 6 stations SOL.A
7B
8B
9B
10B
11B
12B
13B