SMC Networks S0700 Series Manual page 41

SUP block plate
SS0700-B-P
When different pressures, high and low, are
supplied to one manifold, a SUP block plate
is inserted between the stations under differ-
ent pressures.
∗ Specify the number of stations on the
manifold specification sheet.
<Shut off label>
When using block plates for SUP passage,
indication label for confirmation of the block-
ing position from outside is attached. (One
label of each)
∗ When ordering a block plate for SUP incor-
porated with the manifold no., a block indi-
cation label is attached to the manifold.
Mass: 0.3 g
EXH block plate
SS0700-B-R
When valve exhaust affects the other sta-
tions on the circuit, insert EXH block disk in
between stations to separate valve exhaust.
∗ Specify the number of stations on the
manifold specification sheet.
<Shut off label>
When using block plates for EXH passage,
indication label for confirmation of the block-
ing position from outside is attached. (One
label of each)
∗ When ordering a block plate for EXH incor-
porated with the manifold no., a block indi-
cation label is attached to the manifold.
Mass: 0.3 g
Back pressure check valve [-B]
SS0700-7A-1
It prevents cylinder malfunction caused by other
valve exhaust. Insert it into R (EXH) port on the
manifold side of a valve which is affected. It is ef-
fective when a single action cylinder is used or an
exhaust center type solenoid valve is used.
∗ When a check valve for back pressure preven-
tion is desired, and is to be installed only in cer-
tain manifold stations, write clearly the part no.
and specify the number of stations by using the
manifold specification sheet.
∗ When ordering assemblies incorporated with a
manifold, add suffix "-B" to the manifold no.
Mass: 0.1 g
SUP passage
D side
R R
P P
SUP passage blocked SUP/EXH passage blocked
D side
EXH passage
R R
P P
EXH passage blocked SUP/EXH passage blocked
Precautions
1. The back pressure check valve assembly is assembly parts with a check valve
structure. However, as slight air leakage is allowed for the back pressure, take
care the exhaust air will not be throttled at the exhaust port.
2. When a back pressure check valve is mounted, the effective area of the valve
will decrease, by about 20%.
Plug-in
4.2
U side
9.2
U side
S0700
1.5
SJ
SY
SV
SYJ
Shut off label
SZ
VP4
S0700
1.5
VQ
VQ4
VQ5
VQC
VQZ
SQ
VFS
VFR
Shut off label
VQ7
5
649