Connecting The Power Supply For The Emulator - Renesas Compact Emulator M34571T2-CPE User Manual

M34571T2-CPE User's Manual

2.3 Connecting the Power Supply for the Emulator

Connect the power supply for the emulator to the power connector (J1). The specification of the power supply for the emulator
is listed in Table 2.1.
Table 2.1 Specification of power supply of the emulator
Power supply voltage
Figures 2.2 and 2.3 show the specifications of the power connector (J1) and an applicable plug, respectively.
Electrode (+)
Figure 2.2 Power connector specifications
Notes on Connecting a Power Supply of the Emulator:
The power cable included in this product package is colored red (+) and black (-).
Be careful about the polarity of the power supply. Connecting to the wrong electrode could destroy internal
circuits.
Do not apply a voltage exceeding the specified voltage of the product (5.0 V ±5%), because it may cause burn
injuries and the failure of internal circuits.
REJ10J0972-0100 Rev.1.00 February 10, 2006
DC 5.0 V±5％/2 A
Electrode (-)
Figure 2.3 Applicable plug specifications
φ 1.7mm(Inside diameter)
CAUTION
φ 4.75mm
2. Setup
Page 22 of 72