D-3.1 System Or Device; D-3.2 Network Configuration; D-3.3 Physical Layer - Emerson PACSystems RX3i User Manual

User Manual
GFK-2949E
Note:
The selected parameters should be marked in the white boxes as follows:
X
R
B
The possible selection (blank, X, R, or B) is specified for each specific clause or parameter.
A black check box indicates that the option cannot be selected in this companion
standard.
D-3.1 System or device
(system-specific parameter, indicate the station's function by marking one of the
following with 'X')
X
D-3.2 Network configuration
D-3.3 Physical layer
marked 'X')
Transmission speed (control direction)
Unbalanced interchange
Circuit V.24/V.28
Control Functions
In addition, the full specification of a system may require individual selection of certain
parameters for certain parts of the system, such as the individual selection of scaling factors
for individually addressable measured values.
Function or ASDU is not used
Function or ASDU is used as standardized (default)
Function or ASDU is used in reverse mode
Function or ASDU is used in standard and
reverse mode
System definition
Controlling station
definition (Master)
Controlled station
definition (Slave)
(network-specific parameter, all configurations that are used are to be marked 'X')
Point-to-point
Multiple point-to-point
(network-specific parameter, all interfaces and data rates that are used are to be
Circuit V.24/V.28
Unbalanced interchange Balanced interchange
Circuit X.24/X.27
Appendix D
Multipoint
Multipoint-star
Dec 2020
66