Reset Reader To Factory Default (Optional) - Datalogic MATRIX 450 Reference Manual

Hide thumbs Also See for MATRIX 450:

Table of Contents

RAPID CONFIGURATION

Learn

Enter the Learn function by pressing and holding the X-PRESS™ push button until the

Learn LED is on.

Release the button to enter the Learn function. The Learn LED will blink until the

procedure is completed.

The Learn procedure ends when the Image Processing and Decoding parameters are

successfully saved in the reader memory, the Learn LED will remain on continuously, the

Green Spot is activated and Matrix 450™ emits 3 high pitched beeps

If the autolearning cannot be reached after a timeout of about 3 (three) minutes Matrix

450™ will exit without saving the parameters to memory, the Learn LED will not remain on

continuously but it will just stop blinking. In this case Matrix 450™ emits a long low pitched

beep.

10. Exit the Learn function by pressing the X-PRESS™ push button once.

If you have used this procedure to configure Matrix 450™ go to step 9.

NOTE

RESET READER TO FACTORY DEFAULT (OPTIONAL)

If it ever becomes necessary to reset the reader to the factory default values, you can

perform this procedure by holding the X-PRESS™ push button pressed while powering up

the reader. You must keep the X-PRESS™ push button pressed until the power up

sequence is completed (several seconds) and all LEDs blink simultaneously 3 times.

All LEDs remain on for about one second, then off for one second, the Configuration and

Environmental parameters are reset, and the status LED remains on. If connected through a

CBX500 with display module, the message "Default Set" is shown on the display.

The Learn procedure will not recognize Pharmacode symbologies.

red

yellow yellow green green

STATUS

COM

TRIGGER

TEST

FOCUS

Figure 12 – X-PRESS™ Interface: Learn Function

GOOD

READY

SETUP

LEARN

Table of Contents