Siemens LMV50 Series Manual page 95

Β
Building Technologies
Actuator / variable speed drive
Display on the
AZL52
Figure 43: Display on AZL52
Note!
The parameter influences the tolerance of the position assessment for all actuators
(actuators and variable speed drive) at the same time.
Attention!
This parameter may only be set in a way that does not affect the combustion.
It may be necessary to set a higher residual oxygen content on the system or to
install an O2 supervision if this value is increased above the value set in the
delivery state.
Basic Documentation LMV5...
6 Fuel-air ratio control (FARC)
Tolerance
0.3°/0.5%
0.4°/0.5%
0.5°/0.5%
0.6°/0.6%
●
●
●
1.2°/1.2%
95/327
CC1P7550en
22.05.2018