Table of Contents
Advertisement
22.
Attach 2I & 2J - Horizontal Wall Cleats to Wall Extender
bottom framing and Rear Wall top framing so that cleat is flush with
extender framing. There are two short cleats and one long cleat.
Alternate alignment of screws, so half screw into Wall Extender
Framing and half into Rear Wall Top Framing. Use 3 - 1 1/4" Screws
per short cleat and 6 - 1 1/4" Screws on the long cleat.
Advice: Use Interior Door Header
to confirm doorway opening is
66 1/2" wide at top and bottom.
23.
Attach 2EE - Interior Door Header as shown above. Align with top
framing of front walls. Attach with 4 - 2 1/2" Screws.
To complete Wall Section, attach bottom 2x3 wall plates to plywood floor with
2 - 2 1/2" Screws per wall section. Prior to securing, make sure wall panels
are aligned correctly on the floor. Refer to Step 9. Wall siding should overhang
floor while 2x3 wall plates should sit flush with floor.
Toll Free 1-888-658-1658
Optional - Caulking seams will help
prevent moisture from entering at
seam. Caulking not included in kit.
www.outdoorlivingtoday.com
Page 16
Parts
2I - Horizontal Wall Cleat - Long
(3/4" x 3 1/2" x 84") x 1
2J - Horizontal Wall Cleats - Short
(3/4" x 3 1/2" x 26 1/4") x 2
Hardware
S2 - 1 1/4" Screws x 12 total
Parts
2EE - Interior Door Header
(1 1/2" x 3" x 66 1/2") x 1
Hardware
S1 - 2 1/2" Screws x 32 total
sales@outdoorlivingtoday.com
Advertisement
Table of Contents
