Table of Contents
Advertisement
46.
Position and attach 4D - Rear Corner
Filler Trim with 5 - 1 1/2" Finishing Nails per
piece as per Step 45.
47.
Position 4E - Aluminum Door Tracks on bottom of Front Soffits,
spaced approximately 3/8" from Door Header. 4Y - Extra Piece Lap Siding
can be used as a spacer for track. Tracks should meet at the center of the
door opening below middle rafter. Attach with 8 - 1 1/4" Screws per track.
Note: Aluminum track has pre-drilled
holes for screws which do not line
up with rafter ends.
Toll Free 1-888-658-1658
4D - Rear Corner Filler Trim
(3/4" x 2 1/2" x 42") x 4
A wood clamp may be helpful
to hold the track in place while
attaching to Soffit.
www.outdoorlivingtoday.com
Page 27
Gap will be
covered.
Parts
N1 - 1 1/2" Finishing Nails
Door
Header
3/8" Gap between Track and Door
Header. Extra piece of lap siding
can be used as a spacer.
4E - Aluminum Door Track
S2 - 1 1/4" Screws x 16 total
sales@outdoorlivingtoday.com
Hardware
x 20 total
Front Soffit
3/8"
Parts
x 2
Hardware
Tracks meet
in the middle
Advertisement
Table of Contents
