Table of Contents
Advertisement
Plywood flush
with shingles
on inside.
31.
Correctly orientate 3G - Side Roof Panel, with shingles overhanging
plywood on the side of the shed and flush with plywood toward the center of
the shed. Place on rafters with front of plywood just about flush with rafter
ends but just slightly recessed. Doing so allows front facia to sit better.
Roof Panel
centered on
rafter.
32.
For correct Roof Panel position, align panel so plywood sits evenly on Center Rafters. Next, position
3H - Center Roof Panel onto center rafters.
33.
Align plywood of center roof panel so it is tight against the plywood of the side roof panel. Spacing
should be even front and back.
Toll Free 1-888-658-1658
Front of plywood
1/8" recessed
with rafter end.
Shingles overhang
plywood on outside.
www.outdoorlivingtoday.com
Page 21
Parts (Steps 31 - 34)
3G - Left/Right Roof Panels
(51" x 56") x 2
3H - Center Roof Panel
(45 1/2" x 56") x 1
sales@outdoorlivingtoday.com
Advertisement
Table of Contents
