Table of Contents
Advertisement
48.
Locate all four Y35 - Roller Assemblies. Before attaching to top of
doors, assemble the units as shown above. Attach two Roller Assemblies
to each door with 4 - 1 1/4" Screws per Assembly, center on the door
framing 4" from each end as shown above.
Next, take Left Side Door and slide Rollers into the Aluminum Door Track.
Repeat with Right Side Door and slide until doors meet in the middle.
Left Side Door
Toll Free 1-888-658-1658
Wider door trim
towards center.
www.outdoorlivingtoday.com
Twist Roller Cart onto bolt.
After doors are hung, you may need
to adjust this until doors hang
straight up and down at equal height.
Note: If there is a gap between your
doors at the top or bottom, remove the
door and twist the Roller Assemblies to
adjust the height until they hang parallel.
Page 28
Parts
4F - Sliding Doors
(36" x 73") x 2
Hardware
S2 - 1 1/4" Screws x 16 total
Y35 - Roller Assembly x 4 total
Right Side
Door
sales@outdoorlivingtoday.com
Advertisement
Table of Contents
