Huawei SmartLi 2.0 User Manual page 19

SmartLi 2.0
User Manual
●
Drilling Holes
When drilling holes into a wall or floor, observe the following safety precautions:
Do not drill holes into the equipment. Doing so may affect the electromagnetic
shielding of the equipment and damage components or cables inside. Metal
shavings from drilling may short-circuit boards inside the equipment.
●
●
●
Moving Heavy Objects
When removing a heavy or unstable component from a cabinet, be aware of
unstable or heavy objects on the cabinet.
●
●
●
●
●
Issue 09 (2022-01-30)
When climbing a ladder, take the following precautions to reduce risks and
ensure safety:
– Keep your body steady.
– Do not climb higher than the fourth rung of the ladder from the top.
– Ensure that your body's center of gravity does not shift outside the legs
of the ladder.
NO TICE
Obtain consent from the customer and contractor before drilling holes.
Wear goggles and protective gloves when drilling holes.
When drilling holes, protect the equipment from shavings. After drilling, clean
up any shavings that have accumulated inside or outside the equipment.
D ANGER
Be cautious to avoid injury when moving heavy objects.
When moving the equipment by hand, wear protective gloves to prevent
injuries.
Move or lift the equipment by holding its handles or lower edges. Do not hold
the handles of modules (such as power supply units, fans, and boards) that
are installed in the equipment because they cannot support the weight of the
equipment.
Avoid scratching the cabinet surface or damaging cabinet components and
cables during equipment transportation.
When transporting the equipment using a forklift truck, ensure that the forks
are properly positioned to ensure that the equipment does not topple. Before
Copyright © Huawei Technologies Co., Ltd.
1 Safety Information
9