Table of Contents
Advertisement
8.0 FIREPLACE SETUP
8.1 Glass Frame Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly should be done
by a licensed or qualified service person.
8.1.1 Remove Glass Frame Assembly
WARNING: Do not remove the glass assembly when hot.
1.
Remove the safety barrier.
2.
Remove the gas valve access cover by lifting up out of slots.
3.
Locate (2) spring-loaded latches securing the glass assembly at
the bottom of the firebox.
4.
Pull the spring-loaded latches out and down to release the
bottom of the glass assembly.
5.
Lift glass assembly up and off of the (2) tabs located at the top of
the firebox.
8.1.2 Install Glass Frame Assembly
1.
Align the slots on top of the glass assembly over the tabs at
the top of the firebox while lowering the bottom of the glass
assembly into position.
2.
Pull the spring-loaded latches out and up to secure the bottom
of the glass frame assembly to the bottom of the fireplace.
3.
Reinstall valve access cover by setting down into slots.
4.
Reinstall safety barrier.
HUSSONG MFG. CO., INC.
KOZY HEAT FIREPLACES
8.2 Media Installation
Burner and Perimeter
WARNING: DO NOT BLOCK PILOT WITH MEDIA. A BLOCKED PILOT MAY
CAUSE DELAYED IGNITION.
8.2.1 Burner Media Kits
(#903-LAV, #304-COP, #304-BLK)
1.
Install an even layer of your chosen media across the whole
burner. See FIGURE 8.1 below.
2.
Save any unused media for later use.
8.2.2 Perimeter Media Kits (optional)
(#904-LAV, #307-COP, #307-BLK, #105-VERM, #104-SAND-B)
1.
Install an even layer of media across the front and rear perimeter.
See FIGURE 8.1 below.
2.
Save any unused media for later use.
Burner media installation
Install an even layer across the whole burner (shaded area)
Perimeter media installation
Install an even layer across the front and rear perimeter (shaded area)
FIGURE 8.1 Media Installation
SECTION 8 FIREPLACE SETUP
Glass Frame Assembly–Media Installation
53
#CLW-50-MV
R.1 October 2021
Advertisement
Table of Contents
