Table of Contents
Advertisement
4.2 #CW50-SCK Optional Skim Coat Kit
If you plan to apply a skim coat finish across combustible and non-
combustible materials, using 1/2" thick material, you will need to use
the #CW50-SCK Optional Skim Coat Kit so that the non-combustible
material is flush with the finishing flange (edge) of the fireplace.
This kit includes:
(16) self-tapping screws; (2) side panels; (2) top & bottom panels
1.
Ensure the hand bend tabs are bent at a 90° angle for required
clearances. This provides 1/4" of the spacing necessary for a flush
mount installation.
2.
Install panels. Align the panels with the corners of the
finishing flange.
3.
Do not use any screws above the framing when installing the
bottom panel to avoid damaging any of the gas and electrical
components located behind the panel. Refer to FIGURE 4.4 on
page 34 for maintaining the required areas.
FIGURE 4.5 Hand Bend Tab
FIGURE 4.6 Aligned Corners
HUSSONG MFG. CO., INC.
KOZY HEAT FIREPLACES
FIGURE 4.7 Panels Installed
FIGURE 4.8 Installed Panels and Non-Combustible Material
SECTION 4 FACING AND FINISHING
#CW50-SCK Optional Skim Coat Kit
35
#CLW-50-MV
R.1 October 2021
Advertisement
Table of Contents
