U-Line TORK H-7859 Quick Manual

U-Line TORK H-7859 Quick Manual

Advertisement

Quick Links

H-7859
TORK
STAINLESS STEEL AUTOMATIC
®
FOAM SOAP DISPENSER
TOOLS NEEDED
Drill
1/4" Drill Bit
Dispenser x 1
• Do not allow children to play with the dispenser.
• The minimum and maximum ambient
temperatures for correct operation are 32-122ºF.
• Dispenser is not suitable for installation outdoors or
in wet environments. It is not water-resistant.
NOTE: Install dispenser at least 6" above
counter or sink.
1. Tape included template to wall to use as guide.
Ensure template is level. (See Figure 1)
PAGE 1 OF 6
Phillips Screwdriver
Tape Measure
Key x 1
C-Cell Battery x 4

INSTALLATION

1-800-295-5510
uline.com
Level
PARTS

SAFETY

• Operating sound level of the dispenser is less than
70dBa.
• Damaged or malfunctioning product should be
disposed of immediately to avoid injury.
• Product should be disposed of in accordance with
applicable regulations.
Wall Anchor x 4
6"
Screw x 4
Figure 1
0422 IH-7859

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TORK H-7859 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for U-Line TORK H-7859

  • Page 1 H-7859 1-800-295-5510 uline.com TORK STAINLESS STEEL AUTOMATIC ® FOAM SOAP DISPENSER TOOLS NEEDED Drill 1/4" Drill Bit Phillips Screwdriver Tape Measure Level PARTS Dispenser x 1 Key x 1 C-Cell Battery x 4 Wall Anchor x 4 Screw x 4 SAFETY •...
  • Page 2 INSTALLATION CONTINUED 2. Drill four holes using 1/4" drill bit and remove 5. Hold dispenser up to wall and align holes over template from wall. (See Figure 2) screws. (See Figure 6) Figure 6 Figure 2 3. Insert anchors and screws. (See Figure 3) NOTE: Do not tighten screws completely until 6.
  • Page 3 INSTRUCTIONS LOADING 3. Before loading refill, twist nozzle in direction of arrows until it clicks. (See Figure 12) Load four included batteries into back of cartridge. (See Figure 9) Figure 12 Figure 9 4. Flip refill upside down and load into cartridge with nozzle down.
  • Page 4 INSTRUCTIONS CONTINUED INDICATOR LIGHTS 2. Open dispenser cover and remove empty refill. (See Figure 18) Light on front of dispenser will flash red when batteries are low and green when soap refill is low. Figure 18 (See Figure 15) Figure 15 3.
  • Page 5 INSTRUCTIONS CONTINUED 5. Solid light indicates dispenser is ready for use. Figure 24 (See Figure 21) Figure 21 Cartridge 3. Remove old batteries. Replace with four new batteries. Click cartridge back into place. (See Figures 25-27) REPLACING BATTERIES Light on front will flash red when batteries are low. Figure 25 Light will turn off when batteries are completely drained.
  • Page 6 INSTRUCTIONS CONTINUED 4. Solid light indicates dispenser is ready for use. Figure 28 (See Figure 28) OPENING USING KEYED OPTION USING NON-KEYED PUSH BUTTON OPTION Insert key at position A. (See Figure 29) Insert key at position A and rotate counterclockwise to position B.

Table of Contents