Muratec F-114 Service Manual page 139

All manuals and user guides at all-guides.com
Adjustment and Troubleshooting
2) Abnormal Printing
Description: Printing does not work – even after replacing the cable
Printer does not work at all or strange fonts are printed,
Ensure that ECP (best) or SPP is selected
1. Set up the parallel port
in the CMOS (BIOS) setup.
using CMOS SETUP.
Ensure that the correct driver is loaded.
Use the driver supplied on the CD or
downloaded from the web site.
DO NOT use the Microsoft driver supplied
with the Windows operating system. If the
2. Printer Driver Error.
printer is a GDI or SPL type printer ensure
that ALL OTHER GDI or SPL drivers are
uninstalled as Windows allows only 1 of
this type of driver to be loaded.
3. Error message
"insufficient memory".
Delete any unnecessary files to secure
(The printing job sometimes stops due to
enough space on the hard disk and start
insufficient virtual memory, this is
the print job again.
caused by insufficient space
on the hard
disk.)
Service Manual
4-79