Membrane/Display Panel - Landice L-10 Service Manual

Membrane/Display Panel Removal & Installation Instructions:
INTRODUCTION:
This document is for the installation and removal of the Upper Display Board for the L10 Treadmill.
TOOLS REQUIRED:
BEFORE YOU BEGIN:
the line cord is unplugged from the outlet before you begin to replace the upper display board.
Using a Phillips Head Screwdriver, loosen and remove the three screws holding the reading rack
in place. Once the screws are removed, then remove the reading rack.
Using your hand, lift the display panel out from the bottom of the control panel, as shown
BEWARE OF THE WIRING CONNECTIONS ON THE BACK OF THE PANEL.

Phillips Head Screwdriver
Make sure that the treadmill is switched off at the power switch, and
Step 1
Step 2
above.
26