Treadbelt - Landice L-10 Service Manual

INTRODUCTION: This document is for installation and removal of the Treadbelt (#10023) and
flipping the Deck(#10024).
TOOLS REQUIRED:
BEFORE YOU BEGIN:
caps, side frame covers, front, and rear rollers before you can remove the treadbelt. Please refer to
the individual instructions for each if you need assistance.
\
A
C
Remove the front roller as shown in
Remove the (10) Allen bolts keeping the deck in place as shown in
Once the deck bolts are removed, you can now lift the deck up and rest it on the side frame,
allowing you to slide the belt off the deck as shown in
If this is the 1 time replacing the treadbelt, you will need to flip the deck. If it is the 2
st
replacing the treadbelt, you will also need to replace the deck.
Treadbelt Removal & Installation:
 4mm Allen Wrench,
 5mm Allen Wrench
You will need to remove the motor cover, upright base cover, bed end
Step 1

Illustration A. Remove rear roller as shown in
B
D
Illustration
Illustration B.
Illustration C.
D.
time
nd
37