Elevation Motor - Landice L-10 Service Manual

Elevation Motor Removal & Installation:
Elevation Motor Installation/Removal Instructions
This document is for installation and removal of the Elevation Motor (#10064).
INTRODUCTION:
WARNING: THIS IS A HIGH AC VOLTAGE SO BE SURE TO UNPLUG THE TREADMILL
TOOLS REQUIRED:
BEFORE YOU BEGIN:
installing parts. It is also helpful to have something to prop up the front of the treadmill before removing
and installing the Elevation Motor.
A
Place a block or something solid underneath the front of the treadmill, allowing you access to underneath
the motor pan, as shown in
C
Using the Phillips head screwdriver, remove the screw securing the harness cable to the motor pan, as
shown in Illustration C. Then, use the 13mm socket wrench to hold the nut in place, and use the 5/8"
 13mm Socket Wrench
 5/8" Wrench
Phillips Head Screwdriver

Please turn off and remove power from the treadmill before removing or
Step 1
Illustration A. Then, disconnect the elevation harness connector from the
Lower Board (Inverter) as shown in
Step 2
wrench to remove the bolt, as shown in
B
Illustration B.
D
Illustration D.
46