Table of Contents
Advertisement
INSTALLATION
The unit should be mounted using a mounting clamp (not provided), affixing it to the mounting bracket
that is provided with the unit. Always ensure that the unit is firmly fixed to avoid vibration and slipping
while operating. Always ensure that the structure to which you are attaching the unit is secure and can
support a weight of 10 times the unit's weight. Also, always use a safety cable that can hold 12 times
the weight of the unit when installing the fixture. It is recommended that a professional install the
equipment and it must be installed in a place where it is out of the reach of people's grasp in the height
of 0 to 30m.
MULTI UNIT POWER LINKING
Connect the fixtures together in a "daisy chain" by connecting a XLR cable from the output of one
fixture to the input of the next fixture. The DMX output and input connectors are pass‐through to
maintain the DMX circuit when the power to one of the units is disconnected. At the last fixture, use a
line terminator (see DMX Set Up on page 9). Each lighting fixture needs to have an address set to
receive the data sent by the controller. The address number is between 0‐512 (usually 0 & 1 are equal
to 1). The maximum number of fixtures that can be connected on one power cable is 15 fixtures at 120V
or 24 fixtures at 240V (including the first fixture).
Note: Use caution when power linking other fixtures to the PAR Z120/ZP120 RGBW as the power
consumption of other lighting fixtures will vary. The X L R cable cannot be branched or split to
a "Y" cable. Inadequate or damaged cables, soldered joints or corroded connectors can easily
distort the signal and shut down the system.
FUSE REPLACEMENT
Unplug the unit from any power source it may be connected to. Once the power has been disconnected, use a
Phillips-head screwdriver to unscrew the fuse holder located above the powerCON input. Remove the bad fuse
and replace with a new one, and screw the fuse holder back in.
20
Advertisement
Table of Contents
