Primary-Secondary Setup Multiple Unit Power Linking - ADJ MOD STQ User Instructions

P R I M A R Y- S E C O N D A R Y S E T U P
This function will allows the user to link units together to run in a Primary-Secondary set-up. In a
Primary-Secondary set up, one unit will act as the controlling unit and the others will react to the
controlling units operating mode. Any unit can act as a Primary or as a Secondary fixture, however,
only one unit in a series can be programmed to act as the "Primary."
Primary-Secondary Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data
cables to link your units together. Remember that the Male XLR connector is the input and the
Female XLR connector is the output. The first unit in the chain (primary) will use the female XLR
connector only. The last unit in the chain will use the male XLR connector only.
2. Connect the first "Secondary" unit to the "Primary."
3. "Primary" Unit: Activate the "Primary" setting located in the "PERSNLTY" menu.
4. "Secondary" Unit(s): Activate the "Secondary" setting located in the "PERSNLTY" menu.
5. Set the "Primary" unit to your desired mode of operation.
6. The secondary unit(s) will now follow the primary unit.
M U LT I P L E U N I T P O W E R L I N K I N G
With this feature you can connect the fixtures to one another using the power cable input and output
sockets.
NOTE: USE CAUTION WHEN POWER LINKING OTHER FIXTURES AS THE POWER
CONSUMPTION OF OTHER MODEL FIXTURES MAY EXCEED THE MAX POWER OUTPUT ON
THIS FIXTURE! CHECK SILK SCREEN FOR MAX AMPS.
17