Table of Contents
Advertisement
P R I M A R Y- S E C O N D A R Y S E T U P
This function allows you to link units together to run in a Primary-Secondary set-up, in which one unit
will act as the controlling unit and the others will react to the controlling unit's built-in programs. Any
unit can be configured to act as a Primary or as a Secondary, but only one unit in a given system can
be programmed to act as the Primary.
Primary-Secondary Connections and Settings:
1. Daisy chain your units via the XLR connectors on the rear panels of each unit. Use standard XLR
data cables to link your units together. Remember that the male XLR connector is the input and
the female XLR connector is the ouput. The first unit in the chain (primary) will use the female XLR
connector only, while the last unit in the chain will use the male XLR connector only.
2. Use the display screen and control panel to navigate to Personality > Prim/Sec Mode. Select
this sub-menu using the ENTER button, and use the arrows to toggle between "Primary" and
"Secondary". Press ENTER to confirm your selection.
3. Repeat Step 2 for each unit in the system. Make sure that only one unit is designated as the
Primary, while all other units are designated as Secondaries.
4. The secondary units will now follow the behavior of the primary unit.
M U LT I U N I T P O W E R L I N K I N G
This features allows you to connect the fixtures to one another using the power cable input and output
sockets.
The maximum number of units that can be linked in this manner is as follows:
• 3 units when running on 110V power.
• 8 units when running on 240V power.
DO NOT EXCEED THIS MAXIMUM NUMBER WHEN POWER LINKING UNITS!
All linked units must be of the same make and model type. Do not mix and match units!
36
Advertisement
Table of Contents
