Advertisement
2.2
Installation
3
Insert the modular plug of the telephone cord into the modular jack on the Port
card. Let the telephone cord through the ferrite core. Then close the ferrite core.
You can use the following two kinds of Port cards in the KX-TVP200.
(No port cards are installed at the factory.)
•
4 Digital ports expansion card (KX-TVP204)
•
2 Digital/Analog ports expansion card (KX-TVP102)
• One KX-TVP204 (2 jacks) can support four VPS ports using D-PITS Inte-
gration mode only, and KX-TVP204 does not work under other integration
modes (INBAND Integration, None).
• One KX-TVP102 (2 jacks) can support two VPS ports under any integration
mode.
The Number of Ports VPS Cards can support
Card Type
KX-TVP204
KX-TVP102
Note: You can use only one Integration mode among D-PITS, Inband, and None.
To set the Integration mode, please see "4.5.6.3.1 Dialing Parameters".
• There are three SLOTs in the KX-TVP200, and 4 VPS ports are assigned physi-
cally for each SLOT, so 12 VPS ports are physically prepared in total, however
system can support only 8 ports max.
But in case you use the KX-TVP102, only the first 2 ports of the physical 4 ports
of the card will be effective.
For example, when you mount the KX-TVP204 in SLOT1, the VPS supports Port
1-4. But when you mount the KX-TVP102 in SLOT1, the VPS supports only
Port1 and Port2. Please see the following table for all card configurations and the
effective number of ports in each case. When the VPS administrator sets up
parameters for any port ("4.5.3 Port Service" and "4.5.6.2 Hardware-Port
Setting"), please be careful to set up for the proper port number of VPS ports.
2-14
Installation
To extension ports of the PBX or CO line
Integration Mode
D-PITS
Inband/None
4
Not available
2
–10–
Telephone line modular jacks
PORT 1 and 2 PORT 3 and 4
PORT 1
PORT 2
KX-TVP204 KX-TVP102
• Telephone line modular jacks
on the Port card (KX-TVP102)
is at TNV.
2
Not applied.
Advertisement
Chapters
