Circuit Condition Display (Lmon); Dtmf Information Display (Putd) - Panasonic KX-TVP200BX Service Manual

7.1 Utility Commands

7.1.18 Circuit Condition Display (LMON)

Used to display circuit condition every 1.5 seconds on the screen. To end the dis-
play in VT100 mode, input " ". In case of ASCII mode, it is displayed only once.
You can see following Circuit conditions on the screen.
"Ready"
"Incoming Call Service"
"Outgoing Call Service"
"DSP Reset Processing"
"PITS Connect Processing"
"Error/Does Not Exist"
$ LMON
CO No.: Status
1: Ready
2: Ready
3: Ready
4: Ready
5: Ready
6: Ready
7: Ready
8: Ready
9: Error/Not Exist
10: Error/Not Exist
11: Error/Not Exist
12: Error/Not Exist
$

7.1.19 DTMF Information Display (PUTD)

Used to display DTMF tones the VPS is receiving and sending.
In addition to DTMF, the following information is displayed.
• A type of Incoming Call Service (Voice Mail, Automated Attendant, Custom,
Interview) when the caller enters any service.
• One " " means 4 secs while VPS is recording message etc.
Once you enter "PUTD", this mode is kept until you enter "PUTD" again.
Default setting of this mode for all ports is "OFF".
$ PUTD
Target Port :
$
: Possible to serve
: Processing arrival service
: Processing sending service
: Processing DSP reset disposition
: Processing PITS connect disposition
: DSP Card is not loaded.
7-15
Maintenance