AEMC SIMPLE LOGGER II User Manual page 21

Event: Pressing the RESET Button while Recording
(not recommended)
•
The recording session ends and the GREEN LED changes from a
double-blink to a single-blink.
•
The RED LED double-blinks to indicate that the memory is full.
•
Some portion of recorded data will be lost. Sample data is buff-
ered and assembled into small packets before it is written to Flash.
Data that has not yet been written to Flash will be lost.
Event: Pressing the RESET Button when a Recording has Ended
•
The GREEN LED single-blinks.
•
The unit indicates that the memory is full (double-blinking RED).
Event: The Logger is Waiting for a New Recording Session
If the RESET button is pressed when a recording has been scheduled,
the logger will not start recording at the previously programmed date and
time.
The unit indicates that memory is full (double-blinking RED).
NOTE: The resumption of the logger operation in the above situations assumes
that the RESET button cleared the fault(s). The logger will not resume normal
operation if the fault condition still exists.
®
Simple Logger II Model L261
19