AEMC SIMPLE LOGGER II User Manual page 9

3. Control Button (PRESS)
This button marked "PRESS" selects the mode of operation. Use this
button to start or stop recordings, erase the memory, clear alarms and
turn the instrument ON/OFF.
4. Female Type Mini-B USB Connector - located on the bottom of
the instrument
5. Reset Button (not shown)
The RESET button resets the CPU and is located under the top cover.
To access this button, remove the battery compartment cover, remove
the four screws holding the two halves of the case together. The reset
switch is the smaller switch located on the exposed PCB.
6. Flash Upgrade Switches (not shown)
These two switches (accessible from under the top cover), along with
the RESET button (and PC software), are used to recover from a failed
flash upgrade procedure.
WARNING: If the RESET button is pressed when the logger is recording, it will
stop recording and data in memory may be lost.
®
Simple Logger II Model L261
7