Motor Gearbox Inspection And Maintenance Instructions - ETC Vortek NXT User's Operation Manual

Hide thumbs Also See for Vortek NXT:
Table of Contents

Advertisement

11.3 Motor Gearbox Inspection and
Maintenance Instructions
Inspection of the motor brake, mechanical brake, motor gearbox and frequency drive are required
according to the indications below. Inspection and maintenance must be performed by an ETC trained/
authorized person.
WARNING:
Unit/Unit Part
Motor brake
• If used as a working brake:
At least every 3000 operating
hours
• If used as a holding brake:
Every 2 to 4 years, depending on
operating conditions
Mechanical brake
• Every 400 operating hours
Motor and Gearbox • Every 1000 operating hours
Variable Frequency
• The interval depends on outer
Drive
If you open the motor during inspection/maintenance, you have to clean it before you close it.
49
Always disconnect and lock out the hoist main electrical connection from its
power supply before performing any maintenance work inside the motor
control box. Wait at least two minutes before opening the motor control box
to allow any residual energy of electrical components to dissipate.
Frequency
influences and can be very
short; e.g., in the event of high
dust concentration in the
environment.
What to do?
Inspect the brake:
• Measure the brake disc thickness
• Brake disc, lining
• Measure and set working air gap
• Pressure plate
• Driver/gearing
• Pressure rings
• Vacuum up the abraded matter
• Inspect the switch contacts and change
if necessary (e.g., in case of burn-out)
Inspect the brake:
• Check for signs of wear and/or fatigue
• Look for buildup of dust around the
brake mechanism
• Inspect the screw and bolt heads for
signs of fatigue
• While running the hoist, listen for
excessive brake noise
Test the brake in both static and dynamic
conditions
Inspect the motor:
• Check rolling bearings and change if
necessary
• Replace the oil seal
• Clean the cooling air passages
• Touch up or renew the surface/
anticorrosion coating
• Check and clean the air filter
• If applicable, clean condensation drain
hole at the bottom of the fan guard
• Clean clogged bores
Vortek NXT Hoist User Operations Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Evf-0509Evf-0901

Table of Contents