Table of Contents
Advertisement
3:
Locate the Vortek Hoist Installation Kit and retrieve the 9-pin CPC (grey) data cable.
4:
Attach one end of the data cable to the QT1-C Field Service Kit and the other end to the
receptacle on the hoist Motor Control Box [
8.3 Power On
5:
See
7.7 Vertical Mounting
The standard mounting method of a Vortek NXT hoist is to be hung from the structural steel in a
horizontal position. The previous sections detailed this method of mounting the hoist. If you are
planning to mount the hoist vertically, the following procedure provides some guidelines for you to
follow.
1:
Position the hoist in its crate adjacent to the lineset position where you will install the hoist.
2:
Remove the wooden cover, banding and any packing material.
3:
Create two 4.5 m (15 ft) sling assemblies using 3/16" diameter galvanized aircraft cable by
terminating a thimble on each end after securing a 38 cm (15") section of rubber tubing in the
center with cable ties. You use these slings to lift the hoist vertically from its crate.
Installation
Figure 24: Connecting grey cable to hoist
page 32
on
.
38 cm (15")
Rubber Tubing
Figure 25: Sling assembly
Figure 23
Figure 24
and
4.5 m
(15'-0")
1.27 cm (1/2")
OD Maximum
].
26
Advertisement
Table of Contents
