Co 2 Sensor; Connecting The Co 2 Sensor - Binder APT.line C 150 Operating Manual

4.2 CO sensor
2
Connect or remove the CO
the CO sensor before removing or replacing its filter cap. The Teflon filter of the CO
2
and humidity from intruding into the measuring cell. It is available as a spare part. Replace it whenever it
is damaged or soiled.
The accuracy of the indicated values of CO
0.08 vol.-% per 10 mbar / 0.15 psi). In order to compensate this effect when measuring the
CO concentration, the altitude of the installation site above sea level can be entered into the
2
controller (chap. 8.1).
The CO sensor is temperature resistant up to a maximum temperature of 60 °C / 140°F.
2
Excess temperature.
Damage to the CO
∅ Do NOT autoclave the CO
∅ Do NOT expose the CO
The CO sensor head was especially adjusted for the specific chamber. To avoid confusion, an adhesive
2
label with a serial number is adhered to the sensor head. When exchanging the sensor, you must repeat
the CO adjustment.
2
Different CO
Invalid calibration.
∅ Do NOT change the CO
Note down the serial number of the CO
Avoid strong shocks when handling the CO
Shocks of the CO
Damage to the CO
∅ Avoid strong shocks of the CO
4.2.1 Connecting the CO
Turn off the unit. Open the door of the inner chamber and plug the CO
the connection socket located in the upper part of the rear of the inner chamber.
The sensor must click in correctly and sit tightly in the connection socket.
Connecting or removing the CO
Damage to the CO
∅ Connect or remove the CO
C 150 (E2) 06/2011
sensor without rotating and only when the incubator is turned off. Remove
2
sensor.
2
Sensor.
2
sensor to hot-air sterilization.
2
sensor.
2
sensor head.
2
sensor.
2
sensor.
2
sensor.
2
sensor (by putting it down hard, or dropping).
2
sensor
2
sensor during operation.
2
sensor.
2
sensor only with the unit turned off.
2
depends on the ambient air pressure (approx.
2
CAUTION
CAUTION
sensor.
2
CAUTION
sensor (4) without rotating into
2
CAUTION
sensor prevents dirt
2
page 21/78