Brother BES-1261BC Instruction Manual page 38

Chapter 1 Preparation of Embroidery Machine
3. Pass the thread through the upper hole of the 2nd pretension. Push up the tension disc with
your finger, and place the thread under the disc. Then, pass it through the lower hole, and
wind it around the thread breakage pulley twice.
4. Pass the thread through the hole of the upper thread guide (U), wind it into the tension disk
clockwise once, and place it on the spring.
5. Pass the thread through each hole of the upper thread guide (U) and the thread guide (C).
6. After passing the thread through the hole of the thread guide (U), insert the thread into the
right side of the inner thread guide, and pass it through the hole of the thread take-up.
7. Bring the thread to the inner thread guide again to insert it into the hole from the upper
section, then into the lower thread guide.
8. Pass the thread through the hole of the needle bar thread guide, then pass it through the
needle eye, without passing it through the presser foot.
36
BES-961BC BES-1261BC