Brother BES-1261BC Instruction Manual page 27

BES-1261BC
y
1. Remove 3 pieces of fixing screw q,loosen 2 pieces of screw w and remove the color change
cover e.
2. Remove the bolts r and detach the fixing bracket for transportation from the bridge and the
connecting shaft.
3. Loosen the bolts t and move the needle bar case y left side.
4. Press the change bracket collar i against the change case base u, while pressing the left
side change bracket collar o against the change case base u, and tighten the bolts t.Check
that needle bar No.1 and 12 are inserted into the needle plate holes smoothly.
(Notes) Check that ther is no play for the connecting shaft in the horizontal direction.
If the bolt of the right side change bracket collar i is loosened, the change bracket collar i may be
dislocated and adjusting position of the needle bar case y will be required. So don't loosen this bolt.
5. Attach the color change cover e by 3 pieces of fixing screw q and 2 pieces of fixing screw w.
r
t
o
o
q
u
e
BES-961BC BES-1261BC
Chapter 1 Preparation of Embroidery Machine
Bridge
Connecting shaft
Fixing bracket
Fixing bracket B
i
q
w
25