Brother BES-1261BC Instruction Manual page 154

Chapter 9 List of Error Codes
Code
E-02
Overtravel error during home
positioning detection
E-03
Stop SW was pressed during home
positioning
Zero positioning is out of range
E-04
Needle stop position error
E-05
Needle bar case position error
E-06
Needle bar case lock
E-07
X-axis home position error
E-09
Thread breakage error
E-0A
E-14 Y-axis home position error
E-18 X-axis stepping motor connector error
E-21
E-22
E-23
E-24
E-25
E-26
E-27
Area over
E-28
E-29
E-2A
E-2B
E-2C
E-2D
E-2E
E-2F
152
Error
BES-961BC BES-1261BC
Measures
Turn the power off once, then on again. If the same
error occurs again, the area sensor is faulty.
Press and clear the error message. Pressing
STOP
restarts the home position detecting movement again.
Turn the power off once, then on again. If the same error
occurs again, the X- or Y-axis mechanism is faulty.
Adjust the pulley stop position (100 ) above the needle
and press .
STOP
Press . If the error persists, the color-change
STOP
mechanism is faulty.
Turn the power off once, then on again. If the same
error occurs again, the X-axis mechanism is faulty.
After passing through the thread, press
Turn the power off once, then on again. If the same
error occurs again, the Y-axis mechanism is faulty.
Check that the connector of the X-axis stepping motor
is properly connected, and press
Set the embroidering area again or move the hoop to a
sewable position. (The hoop can be moved to a
sewable position by pressing
START
.
STOP
.
STOP
.)