Brother BES-1261BC Instruction Manual page 54

Chapter 2 Embroidering Procedures
Operation panel
52
FLAT CAP
HOOP
Selects the flat or cap hoop. This selection should be done before turning the power ON
to the machine. Selection after turning the power ON may damage the hoop.
Moves the hoop.
Step-back or forward is available during suspension, by one stitch every time the switch
is pressed (Use
Changes the speed range during embroidering (Use
Carries out inching of the hoop when the switch is pressed in the inching mode
Move the cursor for selecting sewing data and an icon.
Moves the needle bar. The needle moves by the diameter every time this switch is pressed.
Change to the screen for selecting sewing data.
BES-961BC BES-1261BC
switches only.)
Contrast volume
Adjusts the screen contrast.
SBUS interface connector
Not used (Do not connects anything.)
RS-232C interface connector
Connect personal computer with BE-100 installed, etc.
switches only).