Brother BES-1261BC Instruction Manual page 156

Chapter 9 List of Error Codes
Code
E-BA Power supply frequency error
E-BC No power error
E-BD Lower shaft flash memory error
E-BE Lower shaft version-up error
E-C1 Area over during embroidering
E-C2
Wiper out error
E-C4 Presser foot down error
E-CB Main(Z) motor speed error
E-CE Cylinder bed position error
E-D0 Power PCB error
E-D1 Cooling fan motor stop
E-D2 Power voltage upper limit error
E-D3 Power voltage lower limit error
X-axis pulse motor overcurrent stop
E-E1
Turn off the power
E-E2
Y-axis pulse motor overcurrent stop
Turn off the power
E-E3
Exhaust fan motor stop
E-E4
Hook motor error
154
Error
BES-961BC BES-1261BC
Measures
Turn the power off once, then on again. If the same
error occurs again, the power PC board or power supply
is faulty.
Press .
STOP
Turn the power off once, then on again. If the same
error occurs, the main PC board is faulty.
Press and clear the error display and upgrade the
STOP
version again.
Set the embroidering area again.
If the wiper is tangled with a thread, remove it. Then
press .
STOP
Press .
STOP
Press and clear the error display. Then press
STOP
If the same error occurs again, there is a possibility that
the spindle is overloaded.
Secure to bed.
Turn the power off once, then on again. If the same
error occurs again, the power PC board is faulty.
Turn the power off. Check that the fan on the left or bottom
rear of the control box is not tangled with a harness, etc.
before turning the power on again. If the same error occurs
again, the fan or the power PC board is faulty.
Press . If the same error occurs again, the power
STOP
PC board or the power supply is faulty.
Turn the power off once, then on again. If the same
error occurs again, the pulse motor or the main PC
board is faulty.
Press . If "OFF" is displayed, turn the power off.
STOP
Check that the fan at the right rear of the control box is
not tangled with a harness, etc. before turning the
power on again. If the same error occurs again, the fan
or the power PC board is faulty.
Finish the test mode or turn the power OFF once, then
ON again. If the same error occurs again, the main PC
board is faulty.
.
START