Brother 8060P MFC-9060 Owner's Manual page 155

DIFFICULTY
® I cannot print from my
Windows Setup
Printing Difficulties application software.
(For MFC-9060
only)
Paper
The machine does not load Check to see if the CHECK PAPER or PRINTER JAM
Handling
paper. The LCD shows
Difficulties
CHECK PAPER or
PRINTER JAM
The machine does not load Reinsert the paper firmly, one sheet at a time.
paper from the manual
feed slot.
How can I clear paper
jams?
Copy Quality
Vertical streaks appear in
Difficulties
copies
Print Quality
Printouts are too dark or
Difficulties
light
Printed pages contain white You may fix this by wiping the scanner windows with a
stripes.
Printed pages are stained
with toner or have vertical
stripes.
Dark Stripes or Toner Stains
Printed pages have white
spots in black text and
graphic areas.
T R O U B L E S H O O T I N G A N D M A I N T E N A N C E
SUGGESTIONS
Make sure the Windows
select it in your application software.
message appears on the LCD. If so, the Multi-purpose
Sheet Feeder may be out of paper or not properly installed.
If it is empty, load a new stack of paper into the feeder and
then press Start. If there is paper in the Multi-purpose
Sheet Feeder, make sure it is straight. If the paper is curled,
you should straighten it. Sometimes it is helpful to remove
the paper, turn the stack over and put it back into the
Multi-purpose Sheet Feeder. Reduce the amount of paper
in the Multi-purpose Sheet Feeder, then try again.
See "Printer Jams".
Sometimes you may see vertical streaks on your copies.
Either the scanner or the primary corona wire for printing is
dirty. Clean them both.
Adjust the print conditions by setting the Print Density
function, It has been factory set to the middle position. See
"Setting the Print Density" in chap. 5.
clean soft cloth. (See "Regular Maintenance" and "Cleaning
the Drum Unit" in this chapter.) If you still see white stripes
or faint images and the display shows CHANGE DRUM
SOON, replace the drum unit with a new one.
White Stripes or
Faint lmages
Clean the machine's interior and the primary corona wire of
toner cartridge. See "Regular Maintenance" and "Cleaning
the Drum Unit" in this chapter. Make sure that the tab of the
corona wire is at the home position. If after cleaning, you
still see dark stripes or toner stains and the display shows
CHANGE DRUM SOON, replace the drum unit with a
new one.
Make sure that you use paper that meets the specifications.
Rough surface or thick media can cause the problem. If you
still see white spots and the display shows CHANGE
DRUM SOON, replace the drum unit with a new one.
White Spots
®
printer driver is installed and you
145