Changing Functions; Changing Procedure - A&D AND TM-2657P Instruction Manual

The multi-functional monitor can be configured for various applications by changing function
settings.
To change function settings, use the buttons located on the rear panel of the monitor while the
monitor is in standby mode.
10.1. Procedure to Change Function Settings
1. In power off mode, hold both the ▲ and SELECT buttons
down and switch the power on.
F01
is displayed in the systolic display section and the
monitor enters the function changing mode.
2. Each time the SELECT button is pressed, the setting item
02
changes to F
3. Each item can be changed using the ▲ button.
4. After completing the settings, switch the power off and then on again.
Setting
Details
items
F01
Not used
F02
Display time
F03
Applied pressure
F04
Not used
F05
IHB
F06
Not used
Print quality/
F07
light or dark
ID and name
F08
printing
Mean arterial
F09
pressure (MAP)
printing
F10
Not used
Measurement
F11
value printing
F12
Graph printing
F13
Not used
F14
Not used
F15
Bitmap printing

CHANGING FUNCTIONS

10.
03
, F ...
Default Diastolic display section
―
, ,
,
―
/
―
〇
〇
―
〇
〇
―
―
〇
, , Measurement result display time (seconds)
, , Applied pressure setting (mmHg)
IHB-mark printing on/off
Printing off
Light printing (high speed)
Standard printing
Dark high-quality printing (low speed)
ID : No
ID : No
ID : Yes
ID : Yes
Mean arterial blood pressure (MAP) printing
/
on/off
High-speed printing
Normal 3-line printing
Big font printing
Table printing
Graph printing off
Pulse fluctuation graph printing
Bitmap printing off
Standard pattern printing
User pattern printing
20
Function
/ Name : No
/ Name : Yes
/ Name : No
/ Name : Yes