Table of Contents
Advertisement
Transmission specifications
1)
Main standard
Supported profiles
Devices that can
be connected
2)
Pairing
A Bluetooth device needs to be paired with a different specific device in order to communicate
with that device. When this monitor is paired with a receiver device, measurement data is
transmitted automatically to the receiver device each time a measurement is made
Follow the steps below to pair the monitor with a Bluetooth compatible receiver device. Also
refer to pairing in the manual of the receiver device. Please use a pairing wizard if it provided.
①
②
③
④
⑤
Bluetooth Ver.2.1 class1
SPP,HDP
●Continua certified devices
●Applications and devices that are compatible with SSP and A&D specifications
However, each device needs an application to receive data.
For connection methods, refer to the manual for each device.
Follow the instructions in the manual of the receiver device to switch it to the
state that a pairing is possible. When pairing this monitor, place it as close as
possible to the receiver device to be paired with.
Hold down the SELECT button and turn on the power.
Press the START/STOP button after "do" is displayed in the systolic display
section and "PAr" is displayed in diastolic display section.
The monitor will be searchable from the receiver device for about one minute
after pressing the start/stop button.
Follow the manual of the pairing receiver device, the monitor performs a
search, select, and pair. If a PIN code is requested by the receiver device,
enter "123456".
"End" is displayed in the pulse rate display section when the pairing is over
successfully on the receiver device side, and the pairing is finished.
If the pairing is failed, "Err" is displayed in the pulse rate display section.
Turn off the monitor and back on again, and then retry from the step ①.
Bluetooth devices described the
Bluetooth logo mark.
Continua certified devices described
with the Continua logo mark.
37
Advertisement
Table of Contents
