A&D AND TM-2657P Instruction Manual page 27

If the high-speed printing mode is used, approximately 700 prints are possible from one
printer paper roll. With 3-line printing mode, 600 prints are possible. When the end of the
printer paper roll becomes pink, replace the paper.
Use thermal paper only.
If the following error codes are displayed in the systolic display section, a printer error has
occurred.
Perform the required countermeasure.
Error code
No printer paper. Install a new printer paper roll.
The printer cover is open. Firmly close the printer cover.
A printer cutter error. Open the printer cover, check the printer paper, and then
close the printer cover.
When no printer error is displayed and the monitor is in standby mode, holding down the ▲
button for 2 seconds will cut the paper.
If the direction of the printer paper is incorrect, printing is not performed.
Use genuine A&D printer paper. If genuine A&D paper is not used, the print may be too
light or paper jams may occur.
On the last 60 cm of printer paper, there are pink end marks (pink lines on both sides).
If these end marks appear, replace the printer paper.
Thermal printer paper is used. Note that discoloration or fading may occur.
Items that will be discolored:
Felt-tip pens and adhesive agents including starch and organic solvents.
Items that can cause fading:
Highlight pens, tape, transparent storage cases, desk pads, sunlight and ultraviolet.
Because of the abovementioned causes, make a copy of measurement results when
saving them.
With high speed and 3-line printing, approximately 700 and 600 prints are possible
respectively (in the case of 30 m standard printer paper and measurement value
printing only.)
Error/countermeasure
Note
17