A&D AND TM-2657P Instruction Manual page 49

4) Bluetooth utility mode
Configure Bluetooth settings for this monitor in Bluetooth utility mode.
To change function settings, use the buttons located on the rear panel of the monitor while the
monitor is in standby mode.
Hold down the SELECT buttons and turn on the
①
power.
"do" is displayed in the systolic display section
and "PAr" is displayed in the diastolic display
section, when the Bluetooth utility mode has
started.
Each time the SELECT button is pressed, the setting
②
changes to "un" / "PAr" → "cLr" / "dAt" → "do" / "PAr" →...
Each item can be performed using the START/STOP button.
③
Pairing
See "11.2.3 2) Pairing" described above.
Unpairing
Devices can be unpaired.
Enter the Bluetooth utility mode. Press the START/STOP button with "un" in the systolic
display section and "PAr" in the diastolic display section.
When "End" is displayed in the pulse rate display section, cancellation of the pairing is
completed, but when "Err" is displayed in it, retry from the step ①.
Data clear
Erase data temporarily stored in the Automatic Blood Pressure Monitor.
Enter the Bluetooth utility mode. Press the START/STOP button with "cLr" in the systolic
display section and "dAt" in the diastolic display section.
When "End" is displayed in the pulse rate display section, cancellation of the data clear
is completed, but when "Err" is displayed in it, retry from the step ①.
This function is valid only with the TM-2657-05.
NOTE
39