Using The Monitor; Installing / Changing The Batteries - A&D UA-1020 Instruction Manual

Hide thumbs Also See for UA-1020:

Table of Contents

1. Remove the battery cover.

2. Remove the used batteries and

insert new batteries into the

battery compartment as shown,

taking care that the polarities (+ and -)

are correct.

Use only R6P, LR6 or AA batteries.

3. Attach the battery cover.

CAUTION

Insert the batteries as shown in the battery compartment. If installed

incorrectly, the device will not work.

When

(LOW BATTERY mark) blinks on the display, replace all batteries

with new ones. Do not mix old and new batteries. It may shorten the

battery life, or cause the device to malfunction.

Replace the batteries two seconds or more after the device turns off.

(LOW BATTERY mark) appears even after the batteries are replaced,

make a blood pressure measurement. The device may then recognize the

new batteries.

(LOW BATTERY mark) does not appear when the batteries are drained.

The battery life varies with the ambient temperature and may be shorter at

low temperatures. Generally, four new LR6 batteries will last approximately

for one year when used twice for measurement each day.

Use the specified batteries only. The batteries provided with the device are

for testing monitor performance and may have a limited life.

Remove the batteries if the device is not to be used for a long time.

The batteries may leak and cause a malfunction.

Using the Monitor

English 8

Step 1

Step 3

Step 2

Step 1

Table of Contents