Table of Contents
Advertisement
Other than the operation of the above ②, the monitor will be searchable from the receiver
device for about one minute after turning on the power. In this operation, "End/Err" are not
displayed in the pulse rate display section when the pairing is over.
（※When reset with the FAST STOP button, searching is impossible.）
Be sure to turn off the power of Bluetooth devices other than the monitor when pairing.
Multiple devices cannot be paired at the same time.
3)
Measurement data transmission
Transmission after pairing is performed automatically by the following procedure.
Enable wireless communication on the receiving device.
Press the START/STOP button to start blood pressure measurement.
①
After measurement, the measurement data is transmitted automatically to the
②
receiver device.
When the function setting F20 of the Automatic Blood Pressure Monitor on which the
monitor is installed is OFF, data transmission and reception are not performed. Ensure
F20 is not set to OFF.
If the receiver device cannot receive measurement data, try pairing again.
The communication distance between this monitor and the receiver device is dependent
on the Bluetooth output class of the receiver device.
When the receiver device is a Class 1 Bluetooth device: Less than 100 m
When the receiver device is a Class 2 Bluetooth device: Less than 10 m
This distance depends on the conditions in the surrounding environment. Please check
that the distance is acceptable for transmitting measurement data.
In cases when the receiver device cannot receive measurement data, the measurement data is
temporarily stored in the monitor memory along with the measurement time. A total of 200 sets of
measurement data can be automatically stored. When the amount of data exceeds 200 sets, the
oldest data is deleted and the new data is stored.
The data stored in the memory is transmitted the next time a connection is successfully made to
the receiver device, and when the reception is confirmed, it is removed automatically. The
amount of data that can be stored temporarily may vary with the receiver device.
NOTE
NOTE
38
Advertisement
Table of Contents
