Fuses - BRP Lynx 600R E-TEC 2018 Original Operator's Manual

MAINTENANCE PROCEDURES
WARNING
Excessively worn skis and/or ski
runners will adversely affect snow-
mobile control.
Blade Ski
NOTE: The XC is not adjustable.
Standard position for Ski is that Ski run-
ner is installed on center holes.
fbl2013-002-014_c
TYPICAL
1. Ski leg
2. Ski
3. Ski Runner
Ski stance can be adjusted by spacer
location. It can be installed inside or
outside of the ski leg
fmo2014-003-009_a
1. Spacer on inside of ski leg

Fuses

Fuse Inspection
The electrical system is protected with
fuses.
Check fuse condition and replace it if
necessary.
To remove fuse from holder, pull fuse
out. Check if filament is melted.
______________
112
A15E0KA
1. Fuse
2. Check if melted
WARNING
Do not use a higher rated fuse.
WARNING
If fuse has burnt out, source of mal-
function should be determined
and corrected before restarting.
See an authorized Lynx dealer for
servicing.
Fuse Location
The fuse box is located behind the front
seat upholstery at the LH front lower
portion of seat.
Refer to the decal inside the fuse box
SPECIFICATIONS
cover or in
identification.
To access the fuse box, carefully pull
seat upholstery out of the aluminum
extrusion by pulling the plastic strip
downwards and sideways at the same
time.
mmo2009-004-036_b
TYPICAL - PULL STRIP
1
2
for fuse