Drive Belt - BRP Lynx 600R E-TEC 2018 Original Operator's Manual

Gearbox Oil Level
With the vehicle on a level surface,
check the oil level by removing the
check plug on the left side of gearbox.
NOTE: It is important that the body of
the vehicle is in horizontal plane.
Oil level must reach the threaded
hole's lower edge.
NOTE: Oil level is allowed to be 2 mm
below the lower surface of the check
hole.
mmo2009-004-033_a
1. Check plug
To add oil, proceed as follows:
1. Remove the filler cap.
mmo2009-004-034_a
TYPICAL
1. Filler cap
2. Pour recommended oil in gearbox
by the filler hole.
Oil level is correct when it just begins
to come out of the check plug orifice.
3. Reinstall check plug and tighten to
specification.
TIGHTENING TORQUE
Check plug

Drive Belt

Drive Belt Inspection
Inspect belt for cracks, fraying or ab-
normal wear (uneven wear, wear on
one side, missing cogs, cracked fab-
ric). If abnormal wear is noted, prob-
able cause could be pulley misalign-
ment, excessive RPM with frozen
track, fast starts without warm-up pe-
riod, burred or rusty sheave, oil on belt
or distorted spare belt. Contact an au-
thorized Lynx dealer.
Spare Drive Belt
A spare drive belt can be stored in the
storage box.
NOTE: Spare drive belt is not supplied
with the snowmobile (Spare drive belt
is supplied with Commander Limited).
CAUTION To avoid damages
to the drive belt, ensure that things
which are carried in storage box are
not damaged the spare drive belt.
Drive Belt Replacement
Drive Belt Removal
1. Remove tether cord cap from en-
gine cut-off switch.
2. Open LH side panel, refer to
TROLS,
EQUIPMENT
3. Remove belt guard, refer to
GUARD REMOVAL
4. Insert the driven pulley expander
provided in the tool kit in the
threaded hole on the adjuster hub
as shown.
______________
MAINTENANCE PROCEDURES
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
INSTRUMENTS
in this section.
.
CON-
AND
BELT
103