BRP Lynx 600R E-TEC 2018 Original Operator's Manual page 93

Clean and lubricate rewind starter
ENGINE
Inspect fuel pump strainer and replace if necessary
FUEL
SYSTEM
Inspect throttle cable
Replace brake fluid
Lubricate the splines of joint between QRS axle and gearbox (XU
models)
DRIVE
Lubricate the splines of joint between driven pulley and QRS axle ( XU
SYSTEM
models)
Replace the following drive pulley wear parts: slider shoes, O-rings
and sliding sheave bushing (E-TEC)
Retighten rear member screws to frame to specified torque (XU)
FRAME
24 N•m (18 lbf•ft)
E-TEC: Inspect oil pump strainer and clean if needed
ENGINE
Clean 3D rave valves
Replace the following drive pulley wear parts: spring cover bushing
DRIVE
and ramps (E-TEC)
SYSTEM
ELECTRICAL
E-TEC: Replace spark plugs
SYSTEM
Replace engine coolant
ENGINE
FUEL
Replace in-line fuel filter (E-TEC)
SYSTEM
EVERY 6 000 KM (4,000 MI) OR 2 YEARS
(WHICHEVER COMES FIRST)
EVERY 10 000 KM (6,000 MI) OR 3 YEARS
(WHICHEVER COMES FIRST)
_______________
MAINTENANCE SCHEDULE (2-STROKE)
EVERY 5 YEARS
91