BRP Lynx 600R E-TEC 2018 Original Operator's Manual page 144

MONITORING SYSTEM
NOTE: Some of the listed pilot lamps and messages do not apply to all models.
PILOT
LAMP(S) BEEPER
ON
4 short
beeps
every
5
minutes
4 short
beeps
every 30
seconds
Short
beeps
repeating
rapidly
4 short
beeps
every
5
minutes
4 short
beeps
4 short
beeps
—
every
5
minutes
______________
142
MESSAGE
DISPLAY
LOW OIL
ENGINE
OVERHEAT
MUFFLER
ENGINE
OVERHEAT
MUFFLER
OVERHEAT
ECM OVERHEAT
LOW BAT
HIGH BAT
CHECK ENGINE
KNOCK
DESCRIPTION
Four stroke engines: Low engine oil
pressure. Stop vehicle in a safe place then,
check oil level. Fill to proper level. If oil
level was correct, discontinue use and
contact an authorized Lynx dealer.
Engine is overheating, reduce snowmobile
speed and run in loose snow or stop
engine immediately and let engine cool
down. Check coolant level,
MAINTENANCE
. If coolant level is correct
and overheating persists,
authorized Lynx dealer. Do not run the
engine if condition persists.
Reduce speed or stop engine. Let engine
cool down and restart. If overheating
persists, contact an authorized Lynx dealer.
Do not run the engine if condition persists.
Critical overheat. Stop engine immediately
and let engine cool down. Check coolant
MAINTENANCE
level, refer to
level is correct and overheating persists,
contact an authorized Lynx dealer. Do not
run the engine if condition persists.
Critical overheat. Stop engine immediately
and let engine cool down. If overheating
persists, contact an authorized Lynx dealer.
Do not run the engine if condition persists.
Do not run the engine if condition persists.
Indicate a low or high battery voltage
condition. See an authorized Lynx dealer
as soon as possible.
Engine fault, see an authorized Lynx dealer
as soon as possible.
Engine detonation (RPM is limited when
this condition occurs).
– Ensure recommended fuel is used.
– Check fuel quality, replace if necessary.
– If fault still occurs, contact an authorized
Lynx dealer.
refer to
contact an
. If coolant