BRP Lynx 600R E-TEC 2018 Original Operator's Manual page 91

FIRST INSPECTION (4-STROKE) AFTER THE FIRST 500 KM (300 MI) OR
10 HOURS OF OPERATION, WHICHEVER COMES FIRST
Inspect engine seals and gaskets for leaks
Inspect exhaust system and check for leaks
ENGINE
Check coolant level
FUEL
Inspect fuel lines and connections
SYSTEM
Inspect drive belt
Visually inspect drive pulley
Tighten drive pulley retaining screw to specified torque
Inspect driven pulley
Check driven pulley preload
DRIVE
Adjust and align track
SYSTEM AND
BRAKE
Change chaincase / gearbox oil
Change NEW gasket ring with gearbox oil change. Apply LOCTITE 542
on the thread of the plug (XU models)
Adjust drive chain (Not for models equipped with gearbox)
Check brake fluid level
Inspect brake hose, pads and disk
Inspect steering mechanism
STEERING
SYSTEM
Inspect skis and runners
Tighten frame pyramid rod screws to 14 N•m (124 lbf•in)
Retighten rear profile screws (6 pcs) to 40 N•m (30 lbf•ft) (Only XU
models)
FRAME
Retighten rear member screws to frame to specified torque (XU)
24 N•m (18 lbf•ft)
Inspect front suspension
SUSPENSION
Inspect rear suspension (including stopper straps and slider shoes)
FIRST INSPECTION (4-STROKE) AFTER THE FIRST 3 000 KM (2,000 MI) OR
1 YEAR OF OPERATION, WHICHEVER COMES FIRST
ENGINE Change engine oil and filter
_______________
FIRST INSPECTION
89