Soft Reset; Hard Reset - Directed DS4+ Installation Manual

Soft reset

A module reset will only erase the steps performed in "Pre-installation and application warnings" on page 4. The firmware and
settings flashed to the module will not be affected.
If required for your installation, connect all the harnesses to the DS4+, EXCEPT the 12-pin
1
main power harness. Press and hold the programming button, then connect the 12-pin
harness to the module.
Wait 3 seconds until the LED turns ON solid orange then release the programming button.
2
The LED turns ON solid red.

Hard reset

Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings may need to
be reconfigured. Connect your module to a computer and use the web configuration tool to edit its programmable features.
If required for your installation, connect all the harnesses to the DS4+, EXCEPT the 12-pin
1
main power harness. Press and hold the programming button, then connect the 12-pin
harness to the module.
After 3 seconds the LED turns ON solid orange. Keep holding the programming button until
2
the LED flashes red, then orange slowly.
3
Release the programming button. The LED turns ON solid red.
27
Connect all but the
12-pin harness
& &
Solid Release Solid
Connect all but the
12-pin harness
& &
Solid Hold Flashes
&
Release Solid
DS4+ TL4
© 2017-09-25 Directed. All rights reserved.