Directed DIRECTECHS DS4+ Installation Manual

Hide thumbs Also See for DIRECTECHS DS4+:

Installation manual (66 pages)

Installation manual (25 pages)

Installation manual (27 pages)

Table Of Contents

Table of Contents

Quick Links

Download this manual

INSTALLATION GUIDE

SUBARU3

This product is intended for installation by a professional installer only! Attempts to install this

product by a person other than a trained professional may result in severe damage to a vehicle's

electrical system and components.

2017-09-26

DS4+

Table of Contents

Summary of Contents for Directed DIRECTECHS DS4+

Page 1 SUBARU3 Designed by Installers for Installers © 2017 Directed, Vista CA This product is intended for installation by a professional installer only! Attempts to install this product by a person other than a trained professional may result in severe damage to a vehicle’s electrical system and components.
Page 2: Table Of Contents
Contents Warning! Safety first ........................3 Introduction ............................ 4 Pre-installation and application warnings ..................4 Vehicle application guide ......................5 Wiring connections ......................... 6 Main harness (H1), 12-pin black connector .................. 6 Relay harness (H2), 10-pin white connector .................. 6 Data harness (H3), 8-pin white connector ..................
Page 3: Warning! Safety First
The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation.
Page 4: Introduction
The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin. The siren is only available with the Directed Digital remote start and security system. Additional parts required (maximum required): Resistor 100Ω...
Page 5: Vehicle Application Guide
Legend: PK: Transponder & Immobilizer Override CC: Comfort & Convenience Controls DL: OE Door Lock & Alarm Controls RS: Remote Start & Engine Controls SS: Integrated Security & Monitoring ST: Function/Feature Status DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 6: Wiring Connections
(-) PTS Output H3/7 Orange/Black Immo. Data H3/8 Yellow/Black No Connection If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 7: Analog Input/Output Harness (H4), 22-Pin White Connector
If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. Note that they are low current and a relay may be necessary. DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 8: Installation (Wiring Diagrams, Fuse Selection & Vehicle Wiring Reference Charts)
Refer to the Vehicle Wiring Reference Charts on next pages for wire colors and location. It is important to check that the fuses are positioned correctly. Junction connector (White conn. at driver’s kick pannel) DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 9 HS CAN 2 Low Data Connector C - Keyless Access Module right of BCM. White Hatch Release Blue BCM under drivers dash. White Immo. Data Green/Black Data ECM on passenger fender. Black DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 10 Connector C - Keyless Access Module right of BCM. White HS CAN 2 Low Data Connector C - Keyless Access Module right of BCM. White Immo. Data Red/White Data ECM behind glove box. White DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 11 38 38 37 37 Immo. Data Immo. Data Keyless Access Module 1514 131211 10 9 8 7 6 5 16 151413 121110 9 8 7 282726 252423 222120 191817 2928 272625 242322 212019 DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 12: Type 2
Yellow, pin 25 Junction connector 7 6 5 (White conn. at driver’s kick pannel) 1615 12 11 It is important to check that the fuses are positioned correctly. (White conn. behind glove box) DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 13 Trunk Release (4 door) Black/Blue 5-wire BCM under drivers dash. White Red/Yellow or Immo. Data Data ECM behind glove box. White Yellow Trunk Release (5 door) Green/Red BCM under drivers dash. White DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 14 Trunk Release Yellow/Blue BCM under drivers dash. White Keyless Access Module 1514 131211 10 9 8 7 6 5 16 151413 121110 9 8 7 282726 252423 222120 191817 2928 272625 242322 212019 DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 15: Type 3
Refer to the Vehicle Wiring Reference Charts on next pages for wire colors and location. It is important to check that the ECM conn. fuses are positioned correctly. (White bottom connector passenger side under hood) DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 16 Connector B - Keyless Access Module behind cluster. White Lock Brown/White Rear of dash fuse box. White Unlock Brown/Black Rear of dash fuse box. White Immo. Data Red/White Data ECM passenger side underhood, bottom connector. White DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 18: Type 4
It is important to check that the 23 22 21 20 27 26 fuses are positioned correctly. 35 34 31 30 29 28 33 32 Relay Holder (White conn. behind dash fuse box) DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 19 Unlock Brown/Black BCM right of steering column. White Trunk Release BCM right of steering column. White Immo. Data Red/White Data ECM behind glovebox. White White Relay holder behind dash fuse box. White DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 20 Relay holder behind dash fuse box. White Keyless Access Module 1514 131211 10 9 8 7 6 5 16 151413 121110 9 8 7 282726 252423 222120 191817 2928 272625 242322 212019 DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 21: Key2Go
Any first-time user must re-register to gain access to Key2GO, and some additional information will be required to complete the registration process, such as your Directed account number and store name. Key2GO is compatible with XKLoader2 and the online web tool, as well as XKLoader3 and the Directechs Mobile application.
Page 22: When Used In Conjunction With Smartstart
Remove the module from the vehicle and reconnect it to your computer. The Directechs web site will automatically recognize that you are moving on to the second phase of the programming sequence. Select the method and click on Submit Key2GO Request. DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 23: Led Diagnostics And Troubleshooting
Flashes orange Key2GO programming. slowly Module was successfully programmed Normal operation. Solid green x with all functions. 3 secs Module was successfully programmed without transponder Normal operation. Solid orange x functions. 3 secs DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 24 If the bypass module fails to flash, it did not receive the signal. Commands can come from RF or D2D. AUX1 command received. Flashes orange x 4 AUX2 command received. Flashes orange x 5 AUX3 command received. Flashes orange x 6 DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 25 The vehicle was detected as moving, which prevents the system from shutting it down. Flashes red x 4 Analog error codes Description Troubleshooting DEI feature error. A feature config file mismatch was detected. Please contact Technical Support. Flashes red, green & orange DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 26: Soft Reset
After 3 seconds the LED turns ON solid orange. Keep holding the programming button until & & the LED flashes red, then orange slowly. Solid Hold Flashes Release the programming button. The LED turns ON solid red. & Release Solid DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 27: Learning The Tach (Not Needed With Virtual Tach)
Important! After successfully learning Virtual Tach, a small minority of vehicle starters may over crank or under crank during remote start. Use the VirtualTach Fine tune feature in the configuration wizard to adjust the starter output time in 50mS increments to compensate for such an occurrence. DS4+ SUBARU3 © 2017-09-26 Directed. All rights reserved.
Page 28: Limited Lifetime Consumer Warranty
Directed dealer, the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer’s name, telephone number and address;...
Page 29: Quick Reference Guide
Typically, users would have to remote start their vehicle, then get inside and press • Directed SmartStart application via your smartphone. the PTS button to perform a takeover. There is therefore a physical action required to drive away. With Get In and Go, you simply remote start the vehicle, unlock the If applicable, you can also start the engine remotely by pressing the Lock button 3 doors, get in and go...
Page 30 * Press & hold for 5 seconds to activate the trunk release (optional). * Icon and remote appearance may differ depending on the model purchased. SmartStart compatible This system is compatible with Directed SmartStart. For a complete list of supported features, please visit www.mysmartstart.com. What is SmartStart? Now you can remote start, lock and unlock your car just by pushing a button on your smartphone;...

Directed DIRECTECHS DS4+ Installation Manual

Quick Links

Related Manuals for Directed DIRECTECHS DS4+

Summary of Contents for Directed DIRECTECHS DS4+

Table of Contents