Standard Operation; Keypad - Beckman Coulter Optima L Series Instructions For Use Manual

Run Preparation

Standard Operation

3
Turn the key to the left to select the zonal position for runs that require that the zonal rotor be
loaded and unloaded while spinning.
The key should not be removed during a zonal operation.
NOTE
As a safety feature, after you press
it out of the zonal position then back into the zonal position. Then press
again to begin the zonal run (see
Figure 2.1 Inserting the Key Into the Interlock Switch
Standard Operation

Keypad

Use the keypad to make numerical entries. As you enter each digit, the digits already entered move
one place to the left in the display. Use the
CE (Clear Entry)
The key can clear a value after a parameter key has been pressed (if the instrument is in the
CE
editing mode), or it can clear a diagnostic message.
* Turn the key to the right to select normal operation and to the left to select zonal operation.
2-2
and
ENTER/RECALL START
CHAPTER 3, Run Procedure).
*
and
CE ENTER/RECALL
, you must reset the key by turning
and
ENTER/RECALL
keys as follows.
PN LL-IM-12AB
START